Worx WX368 Series, Original Instructions Manual

Page: 12 / 124

Lithium-Ion cordless hammer drill EN
12
housing on the back of the drill. It can be used to
keep the drill level during vertical drilling operation.
11. DRILLINg
When drilling into a hard smooth surface,
use a center punch to mark the desired whole
location. This will prevent the drill bit from
slipping off center as the hole is started. Hold
the tool firmly and place the tip of the bit at
the point to be drilled. Depress the switch
trigger to start the tool. Move the drill bit into
the workpiece, applying only enough pressure
to keep the bit cutting. Do not force or apply
side pressure to elongate a hole.
Tungsten carbide drill bits should
always be used for concrete and
masonry. when drilling in metal, only use
hSS drill bits in good condition. Always
use a magnetic bit holder (not included)
when using short screwdriver bits. when
screw-driving, apply a small quantity
of liquid soap or similar to the screw
threads to ease insertion.
12. DISPOSAL OF AN ExhAuSTED
BATTERy PACK
Li
To preserve natural resources, please
recycle or dispose of the battery pack
properly. This battery pack contains
Lithium batteries.
Consult your local waste authority for
information regarding available recycling and/
or disposal options. Discharge your battery
pack by operating your drill, then remove the
battery pack from the drill housing and cover
the battery pack connections with heavy-duty
adhesive tape to prevent short circuit and
energy discharge. Do not attempt to open or
remove any of the components.
pROBLEM SOLuTION
1. why DOES ThE DRILL NOT TuRN ON
whEN yOu PRESS ThE SwITCh?
The forward and reverse switch, which is on
top of the trigger, is positioned in the lock
function. Unlock the forward and reverse
switch putting it into the required rotation
position. Push the trigger and the drill will
start to rotate (See Fig.B).
2. ThE DRILL STOPS BEFORE ThE
SCREw IS COMPLETELy TIghTENED.
why?
Verify the torque position of the torque
adjustment ring, you can find the torque
adjustment ring between the chuck and the
drill body. Position 1 is the lowest torque
(screw driving force) and position 20 is the
highest torque (screw driving force). Position
is for drill operation. Regulate the torque
adjustment ring to a higher position to reach
the best result (See Fig.E).
3. I CAN NOT FIT ThE BATTERy INTO
ThE BATTERy ChARgER. why?
The battery can be inserted into the charger
only in one direction. Turn the battery around
until it can be inserted into the slot, the red
LED light should turn on when the battery is
charging.
4. REASONS FOR DIFFERENT ChARgINg
TIMES
Charging time problems, as above, and
having not used a battery pack for a prolonged
time will reduce the battery pack working time.
This can be corrected after several charge and
discharge operations by charging & working
with your drill. Heavy working conditions such
as large screws into hard wood will use up the
battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack
below 0
o C and above 30 o C as this will affect
performance.
MAINTENANCE
Remove the battery pack from the tool
before carrying out any adjustment,
servicing or maintenance.
There are no user serviceable parts in your
power tool. never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.