Worx WX261, Original Instructions Manual

Page: 11 / 104

11
Cordless Brushless Impact Driver EN
ACCESSORIES
WX261 WX261.9
Battery Pack
(WA3551)
1 /
Charger(WA3880) 1 /
50mm
screwdriver bit
(PH2)
1 1
Hook 1 1
Bit clip 1 1
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice .
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
Intended Use
This tool is intended for the fastening and loosening of
bolts, nuts and various threaded fasteners. This tool is
not intended for use as a drill.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Checking the Battery Pack Condition See Fig .A1
Removing the Battery Pack See Fig. A2
Charging the Battery Pack See Fig. A3
Installing the Battery Pack See Fig. A4
ASSEMBLY AND ADJUSTMENT
Assembling the Hook and Bit Clip
See Fig. B1,
B2, B3, B4
Inserting the Bits See Fig. C1
Removing the Bits See Fig. C2
Forward / Reverse / Lock
WARNING: Never change
the direction of rotation
when the chuck is rotating,
wait until it is stopped!
See Fig. D1,
D2, D3
OPERATION
Operating the On/Off Switch
WARNING: Do not operate
for long periods at low
speed because excess heat will
be produced internally.
Variable 3-Speed
Press the red button to select
preferred rotation speed, levels 1
to 3, with 3 being the fastest. The
operating speed will be illuminated.
See Fig. E
LED Light Indicator
Before operation, the light will be
activated when the On/Off switch
is slightly depressed, and will
automatically turn off 10 seconds
after the On/Off switch is released.
The tool and battery are equipped
with a protection system. The Light
will quickly flash (approximately once
a second, and stop flashing when
you release the trigger), the system
will automatically cut off power to
the tool to extend battery life. The
tool will automatically stop during
operation if the tool and/or battery
are placed under one of the following
conditions:
• Overloaded:
The tool is operated
in a manner that causes it to draw
an abnormally high current. In this
situation, release the Trigger Switch
on the tool and stop the application
that caused the tool to become
overloaded. Then pull the Trigger
Switch again to restart.
• Overheated:
Under the condition
above, if the tool does not start, the
Tool and Battery are overheated. In
this situation, let the Tool and Battery
cool before pulling the Trigger Switch
again.
• Low battery voltage:
The
remaining Battery capacity is too low
and the tool will not operate. In this
situation, remove and recharge the
Battery.
WARNING:
To turn on the
light, press the On/Off switch
and make sure the Forward/Reverse
Rotation Control is on right/left
position.
See Fig. E
TROUBLE SHOOTING
1. I CAN NOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only in