8
position. To clamp the auxiliary handle rotates the handle clockwise. To
loosen the auxiliary handle rotate the handle anti-clockwise (See Fig. C).
Warning: Always use the auxiliary handle.
FORWARD AND ReVeRse ROTATION CONTROL
With the drill pointing away from you, push the Forward And Reverse
Rotation Control (3) to the left “
“for forward rotation. Push the
Forward And Reverse Rotation Control (3) to the right for reverse
rotation “
“.
Warning:
Never change the direction of rotation while the
tool is rotating, wait until it has stopped.
ADJUsTABLe DePTH sTOP
Fit the drill bit into the chuck. Loosen the depth stop by rotating
the handle anti-clockwise. Slide the depth stop until the distance
between the depth stop end and the drill bit end is equal to the depth
of hole/screw you wish to make. Then clamp the depth stop by
rotating the handle clockwise.
FUNCTION MODe seLeCTION (see Fig. D)
The operation of the gearbox for each application is set with the
function mode selection switch (4), To change between functions,
depress the unlocking button (12) and rotate the selector to the
desired operating mode.
For simultaneous drilling and impacting of
concrete or masonry, choose the Hammer
drilling position.
7
8
9
For drilling into steel, wood and plastics
choose the Rotary drilling position.
For impacting only - for light chipping,
chiseling and demolition applications choose
the Hammer position.
Warning: The operating mode selector switch may be
actuated only at a standstill.
Warning: Prolonged use will cause the aluminum housing
to become hot, do not touch.
Working hints for your drill
(hammer)
If your power tool becomes over heated, set the speed to maximum
and run no load for 2-3 minutes to cool the motor. SdS-plus tungsten
carbide drill bits should always be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good condition.
Where possible use a pilot hole before drilling a large diameter hole.
Maintenance
Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
