Worx WT463, Original Instructions Manual

Page: 11 / 96

Jigsaw EN
11
be observed.
ASSEMBLY AND OPERATION
Action Figure
Blade Installation See Fig. A1
Blade Removing See Fig. A2
Variable Speed Control See Fig. B
Pendulum Function See Fig. C
ON/OFF Switch See Fig. D
Lock-On Button See Fig. D
Straight Cut and Curve Cut
See Fig.
E1,E2
Bevel Cut See Fig. F,G
Plunge Cut See Fig. H
Parallel Guide See Fig. I1,I2
Blade Storage See Fig. J
Vacuum Adaptor See Fig. K
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid
a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
TROUBLESHOOTING
Symptom Possible Causes Possible Solution
Tool will not start when
power on
• Power cord is not plugged.
• Check to make sure power cord is
connected well into a working outlet.
Poor cut quality
• Blade is worn out.
• Blade is assembled incorrectly
• Pushing rate is too fast.
• Make sure the blade is sharp and
not broken.
• Make sure the blade is installed properly.
Push the machine slowly.
Work efficiency is low.
• Blade is worn out
• Incorrect speed setting
• Incorrect Pendulum function
setting
• Change to a new blade.
• Adjust the variable speed control
according to the material
• Adjust the pendulum function
control according to the material
Blade is not clamped tightly
by the Blade Holder.
• Blade is not inserted into
place fully.
Dismantle the blade and reinstall it
correctly.