13
12
13
12
Cordless lawn mower
EN
ASSEMBLy
ImPORTANT!
Before you assemble
the lawn mower, check the accessories
according above information, make sure the
accessories are completed.
1. FITTING ThE hANDLE (See Fig.B1, B2,
B3)
1) Insert the lower handle (9) into the holes
on the deck provided.
2) Secure with the screws provided.(Fig B1)
3) Attach the upper handle (1) with the bolts
and lock cam lever (8) to the lower handle
(9). (Fig B2)
4) tightening the two Lock cam levers.
Check that the handle is FuLLY secured.
the cam lever pressure can be adjusted
by adjusting the lock cam lever (8)
clockwise/counter-clockwise. DO NOt
OVEr tIGHtEN.
NOTE:
Ensure the bolts are fully inserted
through the handles before fitting the handle
knobs.
5) Attach the cable clips (3) provided, to the
upper and lower handle. Insert the cable
into the clips ensuring there is enough
cable slack .(Fig B3)
2. GRASS COLLECTION BAG ASSEmBLy
Connect the grass box handle to the box top
as shown in Fig C1-C4.
Step 1. Press the front of the handle briefly.
(Fig C2)
Step 2. then push it forward. (Fig C2)
Step 3. Push down the back of the handle. (Fig
C2)
Step 4. Clip the plastic clips over the metal
frame. (Fig C3)
wARNING: Don’t fit the handle in
reversed direction. Fit the handle as
shown in Fig C1.
3. GRASS COLLECTION BAG FITTING
(See Fig D1, D2, D3)
1) turn the mower off, wait until blade stops
and remove safety key (7).
2) raise the safety flap (10) and hold it up.
3) Pick up the grass bag by the handle, and
position grass bag on the lower hooks (a)
on the mower deck (Fig. D2).
4) release the safety guard to lock the grass
bag into position. Ensure the grass bag is
installed securely (Fig. D3).
NOTE:
Depress the grass bag slightly to
ensure that it is completely installed.
4. REmOVING/EmPTyING
Hold the grass bag, lift the safety flap (10) and
hold up. remove grass bag (5).
wARNING:
Always check the safety
flap can close the discharge outlet
tightly before using. Never lift the safety flap
(10) when the lawn mower is being used
without fitted grass bag.
5. FITTING/REmOVING BATTERy (See
E1, E2)
REmOVING BATTERy
Pull out the battery with the battery handle
directly. (See E1)
NOTE:
Be careful not to drop the battery onto
your foot or on the ground when removing it.
FITTING BATTERy
Put the battery into the battery container;
make sure the battery is fitted correctly. (See
E2)
OPERATION
1. STARTING AND STOPPING (See F1,
F2)
wARNING:
the blade continues
to rotate for a few seconds after the
machine is switched off. Allow the motor/blade
to stop rotating before switching “on” again.
Do not rapidly switch off and on.
STARTING
1) Insert safety key into the housing of the
switch box.
2) Slide the key to the right and hold in
position.
3) Pull the lever bar towards the handle and
the mower will start.
4) release the safety key.
STOPPING
release the switch lever.
