13
12
High pressure cleaner WG600E WG601E WG602E
using the rotor (turbo) nozzle might not be
the best solution for cleaning dirt especially
if the surface is painted or has delicate
parts it may get damaged. In that case
a suitable brush may be use instead to
remove dirt.
Wood and Vinyl decks (Nozzle)
1. Divide your work area into sections and
clean each section individually for best
results.
2. Rinse at high pressure using the fixed
spray nozzle keeping the tip of the nozzle at
least 15-25cm away from the surface.
3. If using the rotor (turbo) nozzle with direct
spray increase the distance from the
surface.
Note:
If your deck is made of a softer wood
increase the minimum distance from the
nozzle tip.
cement patios, stone, and brick (Nozzle)
Rinse at high pressure in a sweeping motions
while keeping the nozzle tip approximately
7-15 cm away from the surface. Increase the
distance if using the direct spray from the
rotor (turbo) nozzle or if the patio slabs have
damaged grouting or use a sand filler.
Wood and Vinyl decks, cement patios,
Stone, and brick (patio cleaner WG602e
only)
1. Attach patio cleaner to lance.
2. Adjust water pressure on patio cleaner.
Higher pressure is suited for brick, stone,
and concrete and lower pressure is suited
for wood.
3. Divide your work area into sections and
clean each section for best results. Using
patio cleaner make sweeping strokes to
clean a section then move on.
cars, boats and motorcycles
1. To achieve best results clean one side at a
time.
2. Apply foam using the high pressure foam
nozzle to one side and then rinse it off
using the fixed spray nozzle in a sweeping
motion. Maintain a distance of at least
20cm away from the cleaning surface. If
using a direct spray from the rotor (turbo)
nozzle, maintain a further distance.
3. Wipe the surface dry using an appropriate
cloth for a highly polished finish and shine.
NotIce!
Never clean the engine or motor
using this product.
After use
1. Release the trigger.
2. Turn the on/off switch to “O” (off).
3. Turn off the water supply tap.
4. Press the trigger to relieve the pressure still
present inside the product and hose.
5. Lock the trigger by pressing the lock button
located on the grip.
6. Disconnect the water hose from the water
filter inlet.
7. Disconnect from the power supply/outlet.
8. If you will not be using this product for
a long period of time, dismantle the
accessories.
9. Check, Clean and store the product.
MAINTENANcE
Before performing any inspection,
maintenance and cleaning disconnect from
the power supply and let the product cool
down.
Inspect the product for damaged or worn parts
before each use. Do not operate it if you find
damaged or worn parts. Contact your supplier
or the manufacturer for replacement parts.
filter maintenance
1. Unscrew the water filter/hose connector
from the back of the machine.
2. Use a blunt tool to remove the rubber seal
from the water filter/hose connector.
3. Use a blunt tool to remove the water filter
from within the hose connector.
4. Rinse the parts with clear water before
reassembling.
5. Insert the water filter into the hose
connecter in the same manner in which
you took it out in back into the hose
connector using your fingers.
6. Insert the rubber seal back into the water
filter/hose connector.
