Cordless Li-Ion Blower/Sweeper
EN
11
3. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. B)
Depress the battery release button (6) to
release battery pack from your tool. After
recharging, insert the battery pack into
tool’s battery port. A simple push and slight
pressure will be sufficient.
4. STARTING/STOPPING (See Fig. C)
Starting
Move the On/Off switch (2) to the “I” On
position.
Stopping
Move the On/Off switch (2) to the “O” Off
position.
WARNING!
The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down.
5. USING THE BLOWER (See Fig. D)
The blower is intended for residential use
only. Use the blower outdoors to move
debris from hard surfaces. This blower is not
designed to clear leaves from large grassy
areas, or move wet, heavy debris.
USER TIPS
- Hold the blow tube approx 7” above the
ground when operating the tool.
Use a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
- After blowing the debris/leaves into a pile, it
is easy to dispose of the pile.
CAUTION!
- Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near bystanders
or pets.
- Use extra care when cleaning debris from
stairs or other tight areas.
- Wear safety goggles or other suitable eye
protection, long pants, and shoes.
STORAGE
WARNING! Store the blower
indoors, in a cool dry location, out
of reach of children and animals.
1. ASSEMBLY THE WALL MOUNT
BRACKET
Attach the wall-mount bracket to the wall with
the screws provided.
Tighten all the screws securely. Carefully
check the bracket after mounting to make sure
that no movement can occur during use. (See
Fig. E1).
WARNING!
Always make sure your
wall-mount bracket is securely mounted
to the wall. Failure to do so could result in
an accident, resulting in possible serious
personal injury.
2. STORING YOUR BLOWER
The blower can be stored into the wall mount
bracket (7) as illustrated (See Fig. E2).
Store in a dry place where your blower can be
protected from damage.
CLEANING THE TOOL
Clean the tool regularly.
WARNING!
Keep your product dry.
Under no circumstances spray with
water.
- To clean the tool, use only mild soap and a
damp cloth.
WARNING!
Do not use any type of
detergent, cleaner or solvent which
may contain chemicals that could seriously
damage the plastic.
- Self lubricating bearings are used in your
product, therefore lubrication is not required.