Worx WG518E, Original Instructions Manual

Page: 7 / 88

7
Electric Blower EN
becomes damaged during use,
disconnect the cord from the
supply immediately. DO NOT
TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
Do not use the machine if the
cord is damaged or worn.
h) Keep extension cords away
from moving hazardous parts
to avoid damages to the cords
which can lead to contact with
live parts.
i) If an extension cord is used
make sure it is for outdoor
use and marked as such. The
recommended size of extension
cord is not lighter than 2×0.75
mm
2
.
3) Operation
a) Before starting the machine,
make certain that the feeding
chamber is empty.
b) Keep your face and body away
from the feed intake opening.
c) Do not allow hands or any
other part of the body or
clothing inside the feeding
chamber, discharge chute, or
near any moving part.
d) Keep proper balance and
footing at all times. Do not
overreach. Never stand at a
higher level than the base of
the machine when feeding
material into it.
e) Always stand clear of the
discharge zone when operating
this machine.
f) If the machine should start
making any unusual noise or
vibration, immediately shut off
the power source and allow the
machine to stop. Disconnect the
machine from the supply and
take the following steps before
restarting and operating the
machine:
i) Inspect for damage;
ii) Replace or repair any damaged
parts;
iii) Check for and tighten any loose
parts.
g) Do not allow processed
material to build up in the
discharge zone; this may
prevent proper discharge
and can result in kickback of
material through the intake
opening.
h) If the machine becomes
clogged, shut-off the power
source and disconnect the
machine from supply before
cleaning debris.
i) Never operate the machine with
defective guards or shields, or
without safety devices
j) Keep the power source clean of
debris and other accumulations
to prevent damage to the
power source or possible fire.
k) Do not transport this machine
while the power source is
running.
l) Stop the machine, and remove
plug from the socket. Make
sure that all moving parts have
come to a complete stop
- whenever you leave the
machine,
- before clearing blockages or
unclogging chute,
- before checking, cleaning or