Worx Sonicrafter WX671, Safety And Operating Manual

Page: 9 / 16

High frequency multi-function tool WX670 WX671
A1
OPERATION INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
1. MOUNTING THE TOOL (See A1.A2)
CAUTION:
For all work or when changing
application tools,always wear protective
gloves. Danger of injury from the sharp edges of the
application tools. Application tools can become very
hot while working. Danger of burns!
WARNING:
Do not let the segment saw blade
(3) and the straight cutter (4) face backwards
like A2, that may hurt user’s hand.
Unscrew the bolt (7).
Clean the tool holder, the application tool and the bolt
(7).
Place the application tool exactly onto the hex-
shaped tool holder. Pay attention that the application
tool has a flush fit.
Tighten the bolt (7) using the supplied Allen key.
2. MOUNTING / CHANGING THE SANDING
SHEET (See B)
Align the sanding sheet and press it
onto the sanding plate by hand.
Firmly press the power tool with the sanding sheet
against a flat surface and briefly switch the power
tool on. This provides for good adhesion and
prevents premature wear.
If one point has become worn, pull off the sanding
sheet, turn it through 120° and place it on again.
3. OPERATING THE ON/OFF SWITCH
— Switching the power tool ON:
Slide switch (10) forwards (
I
).
— Switching the power tool OFF:
Slide switch (10) backwards (
0
).
4. USING THE VARIABLE SPEED CONTROL
(WX671)
Select oscillation frequency while the motor is
running.
The variable speed control (1) can be used to set
the optimum oscillating frequency according to the
accessories used and the respective application.
High oscillation frequency:
Sanding, sawing, rasping and polishing stone and
metal.
Low oscillation frequency:
Polishing varnishes.
A2
B