Worx Nitro WX020, Safety And Operating Manual

Page: 12 / 16

12
20V Cordless Brushless
Paint Sprayer
WX020
WX020.X
MJMXWYWIMWRSXEHIUYEXIP]QEREKIH
WARNING: To be accurate, an estimation
of exposure level in the actual conditions of
use should also take account of all parts of the
operating cycle such as the times when the tool
is switched off and when it is running idle but not
EGXYEPP]HSMRKXLINSF8LMWQE]WMKRMƼGERXP]VIHYGI
the exposure level over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
6. CONTROLS AND
FUNCTIONS
Volume knob
7IXXLIPMUYMHƽS[F]
turning the volume knob
on the trigger of the
sprayer
%MVƽS[GSRXVSP
8LIEMVƽS[GERFI
EHNYWXIHJVSQF]
XYVRMRKXLIEMVƽS[
control.
Trigger
Pull the trigger to
deliver spray liquid from
the liquid container to
the nozzle assembly,
where it is sprayed.
WIDE NARROW
Spray Width Lever
The spray width lever
determines the width of
the spray pattern.
Air cap ear
%HNYWXXLIWTVE]TEXXIVR
by turning the air cap
ears.
Horizontal pattern
(‘up and down’ spraying
motion)
Vertical pattern (‘side to
side’ spraying motion )
7. INTENDED USE
Interior and exterior painting and staining of decks,
outdoor furniture, fences, and walls
8. OPERATING
INSTRUCTIONS
NOTE: Please read the instructions carefully
before use.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
L
MUYMHTVITEVEXMSR
- Stir the spraying liquid thoroughly.
- Unscrew the container .
- Fill the liquid container to desired
level when the liquid has been appro-
priately thinned**** and strained.
See
Fig. A1,
A2,A3,A4
Turbine assembly
NOTE :
4VIWWERHXYVRPSGOSRSJJHMEP
clockwise to lock on during operation.
See Fig.
B1
Suction tube assembly
- Tube end should be facing toward
the front of nozzle if spraying down-
ward
- Tube end should be facing toward
the rear of nozzle if spraying upward
See Fig.
B2
Container assembly
NOTE: Make sure the container is
XMKLXIRIHƼVQP]
See Fig.
B3
L
MUYMH*PS[WIXXMRK
Selecting the right nozzle according to
your work
Use the srewdriver(not supplied) to
take out the nozzle and replace it with
the right one according to your work.
NOTE : The smaller the diameter of
nozzle is,the more delicate work it can
deal with.
See Fig.
C1,C2,C3