2
Installation
Components of Wireless Readers
In the event the shipping box shows damage on arrival, please note the
damage on the carrier's receipt log.
The supposed contents of your Reader shipment is the following:
1. An R/F Base Station.
2. An antenna that attaches to the back BNC connector of the R/F Base
Station/Decoder box. The 2-way RF Scanner Base Station uses a second
antenna that mounts in the center of the Base Station.
3. The Velcro strips can be used to conveniently attach the reader to the side
of your computer, monitor or desk.
4. A "Y" cable for attaching the Base Station between your computer and
keyboard, OR a serial cable for serial attachment. If you ordered a F30/1
cable, it is convertible to PC or PS/2. If you have a USB only Mac or PC,
you should have a Wedge Saver and C20 cable instead of a "Y" cable.
5. A wireless scanner, (Laser or Linear Imager CCD). Included is a rubber
boot housing to place over the Laser or Linear Imager for durability.
6. A Laser/Linear Imager CCD holder.
7. A
laminated
Wireless Reader Setup Menu sheet.
8. If a serial interface model was ordered, a Worth Data 5v regulated power
supply. DON'T USE ANY OTHER POWER SUPPLIES OR YOU
WILL BURN UP THE BASE STATION.
9. A plastic barpad for entering variable quantity information and
performing the
Link Test without data transmission.
Make sure you have a base and scanner with matching frequencies. First, the
color of the antenna tip of the Laser or Linear Imager CCD scanner should
match the color of the label on the underside of the base station. Also, the color
of the label on the underside of the Laser or Linear Imager should match the
color of the label on the underside of the base station, (black/black,
yellow/yellow, red/red, orange/orange, purple/purple, grey/grey, or brown/brown
matched).
