27
b) Check tire pressure in drive tires.
Inflate drive tires to 20psi (138kPa).
c) Check tire pressure in Caster tires.
Inflate caster tires to 40psi (276kPa).
5.1.13 Check condition of belts:
Service Interval: 40hrs.
Stop engine, wait for all moving parts to stop, and remove key.
Check under engine deck to check pump drive belt.
Remove left and right belt shields on deck and lift out floor pan to inspect deck drive belt.
See Sections5.2.3and 5.2.4. for belt adjustment.
5.1.14 Lubricate grease fitting:
Service Interval: Refer to chart.
Stop engine, wait for all moving parts to stop, and remove key.
LUBRICATION CHART
FITTING
LOCATIONS
INITIAL PUMPS
NO. of PLACES
SERVICE
INTERVAL
Front Caster wheel
hubs
1 2 yearly
Front Caster Pivots
1
2
Yearly
Height adjustment
Shaft Bearing
1 5 40hours
Deck Drive Belt Idler
Arm
1 1 40hours
Brake Brackets
1
2
200hours
Pump Drive Belt Idler
Arm
1 1 40hours
Deck Rear Struts
1
2
40hours
5.1.15Lubricate seat switch actuator:
Service Interval: 160hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Unhook seat latch and tilt seat up.
c) Lubricate switch actuator rod with spray type lubricant or light oil.
5.1.16.
Lubricate brake handle pivot:
Service Interval: 160hrs.
a) Stop the engine, wait for all moving parts to stop, and remove key.
b) Lubricate bronze bushing on brake handle pivot with a spray type lubricant or light oil.
5.1.17
Lubricate brake rod bushings:
Service Interval: 160hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Unhook seat latch and tilt seat up.
c) Lubricate bronze bushing on each end of brake rod shafts with a spray type lubricant or a light oil.
