16
b) Remove four M8 nuts from the bottom of the seat. Retain for use later.
c) Align the bolts on the bottom of the seat with the holes in the seat frame .Place seat on the top of the
frame and secure with four nuts remove in step b.
3.6 INSTALL MOTION CONTROL LEVERS
a) Loosen and remove the two bolts and washers which attach the motion control levers to the control
arm shafts for shipping and the two bolts and washers which are screwed into the control arms shafts.
b) Install the motion control lever onto the control arm shaft (see Figure 4)
Place the lever on the outside of the control arm shaft and secure with bolts and washers .Position the
lever so the bolts are in the center of the slots on the lever mounting plate and tighten until snug.
Repeat on opposite side of unit.
NOTE: There are two lever height options available. Place the levers in the first and the third
hole (from the top) to increase height of the levers, or in the first and the third hole(from the
bottom) to decrease the height of the levers.
c) If the levers do not align with each other, when in the neutral position, loosen the hardware and
make the appropriate adjustment by sliding the lever forward or backward until properly aligned and
tighten hardware.
d) If the ends of the levers hit against each other, while in the drive position, make adjustment by
moving the lever outwards to the neutral lock position and carefully bending them outward. Move them
back to the drive position and check for clearance, repeat if necessary.
FIG4. MOTION CONTROL LEVER ASSEMBLY
3.7 POSITION DISCHARGE CHUTE
Loose two nuts M8 attaching discharge chute. Lower the discharge chute into position. Retighten nuts until
chute is snug but can pivot freely.
3.8 SERVICE ENGINE
Engine is shipped with oil, check oil lever and if necessary fill to the appropriate lever with 10W-40
