![background image](http://html1.mh-extra.com/html/worldlawn/wy28t/wy28t_operators-manual_997940021.webp)
21
Drain oil while engine is warm from operation.
Replace the oil filter every other oil change. Clean around oil filter and unscrew filter to remove. Before reinstalling
new filter, apply a thin coating of oil on the surface of the rubber seal. Turn filter clockwise until rubber seal contacts
the filter adapter; then tighten filter an additional 2/3 to 3/4 turn.
Clean around oil fill cap and remove cap. Fill to specified capacity and replace cap. Use oil recommended in engine
owner’s manual. DO NOT overfill.
Start the engine and check for leaks. Stop engine and recheck oil level.
5.1.9
Check tire pressure:
Service Interval: 40hrs
Stop engine, wait for all moving parts to stop, and remove key.
Check tire pressure in drive tires.
Inflate drive tires to 30psi (210kPa).
Check tire pressure in caster tires.
Inflate caster tires to 30PSI
(
210kPa
)
.
5.1.10
Check condition of belts:
Service Interval: 40hrs
Stop engine, wait for all moving parts to stop, and remove key.
Check all the belts.
Remove the left and right belt shields of deck and lay them aside to inspect belts.
See Sections 5.2.2, 5.2.2.1, and 5.2.3 for belt adjustment.
5.1.11
Lubricate grease fittings:
Service Interval: Refer to chart
Stop engine, wait for all moving parts to stop, and remove key. See the FIG 7.
LUBRICATION CHART
FITTING
LOCATIONS
FITTING
TIMES
SERVICE
INTERVAL
1
1
50hrs
2
1
50hrs
FIG 7