World Cat 230CC, Owner'S Manual

Page: 55 / 62

20 20 World Cat Glacier Bay Edition 2740 Owner’s Manual
54
10.1.8 Raw Water System
The raw water pump and strainer are mounted on the rigging wall in the starboard bilge compartment, which
can be accessed through the motorwell hatch. The strainer is connected to a high speed pickup through the
seacock located on the inboard side of the starboard sponson. The seacock must be open for the system to
work. Similar to the freshwater pump, the raw water system in controlled by a pressure switch set at 60 psi.
The pump will cycle on and off as needed to maintain this pressure. Most owners leave the pump “ON”
throughout the day, and use the system when necessary. On your 2740, the raw water pump feeds the raw
water outlet located on the helm leaning post and the anchor washdown at the bow. A washdown hose
has been included with your boat to use with this system. To view the layout of the water system see the
diagram in section 10.4.2.
10.1.9 Marine Head
Your 2740 comes equipped with a marine head. The control panel for the head
is located on the head instrument panel located on the aft vertical wall of the
console headliner. Power is supplied to this panel through a 25 amp breaker
located on the battery management panel.
Water is supplied to the system from the freshwater tank; therefore, to operate
the toilet the freshwater system must be pressurized. A solenoid, installed
near the head inlet, prevents water from filling the bowl prior to each use. The
macerator pump, located at the rear of the toilet, removes waste from the bowl
and pumps it into the 15 gallon holding tank.
!!! WARNING
If the solenoid fails or becomes locked in the open position, shut off the supply system quickly and
evacuate the bowl.
Control Panel Operations
The top rocker switch will flush the toilet and fill it at the same time once the switch has been
depressed to the right.
The bottom rocker switch performs two functions:
• If depressed to the left it will fill the toilet to a desired level for user comfort.
• If depressed to the right the toilet will be evacuated.
Initial Start Up
On each trip, prior to using the head, complete the following steps:
• Turn on the freshwater system.
• Fill 1/3 of the bowl with water using the lower switch on the control panel.
• Hold down the top switch for 5 seconds to evacuate the bowl and refill with water.