World Cat 230CC, Owner'S Manual, Page: 34 / 62

20 20 World Cat Glacier Bay Edition 2740 Owner’s Manual
33
6.11.7 Freshwater Pump
Supplies pressure to the freshwater system. It contains a pressure switch similar to a residential well pump.
You can leave this appliance on at all times while underway.
6.11.8 Macerator Pump
Used to evacuate waste and debris from fishboxes or to remove waste from marine head holding tanks.
6.11.9 USB Outlets
Located strategically throughout the boat, these outlets provide power to aftermarket accessories such as
cell phones, electric reels, and spotlights. Each outlet is independently wired to the fuse panel.
6.11.10 Livewell and Livewell Pump
The 2740 has a 20 gallon standard livewell system. which is supplied by a dual purpose
livewell pump. The pump is located in the port bilge compartment and can be reached
through the inspection port in the motorwell. The wiring is secured to the pump using a
tie-strap, and must be disconnected prior to removing the pump.
The livewell pump draws water through the strainer mounted on the inboard side of the port
sponson. A seacock is installed between the pickup and the pump to allow you to seal the
system between use, or in the event of a plumbing failure. To operate the livewell, first verify
that the seacock is in the open position, then engage the livewell pump using the switch at
the dash. Water will fill the tank until it is level with the overboard drain, which evacuates
water through the hullside.
NOTICE
While underway, leaving your livewell seacock open could result in inadvertently filling your livewell.
To prevent this, close the seacock when the pump is not in operation.
NOTICE
Operating the engines in reverse can cause excessive ventilation near the livewell intake, causing the
pump to airlock. To prevent this, turn the pumps “OFF” prior to any continuous or high speed reverse
operation. If your pump does becomes air locked, turn the pump “OFF” for 15 to 30 seconds to
correct the problem.