Operation
32
GB
After SAleS Support
32
IRE
0044 151 649 1500
0044 1890 946 244
GB
IRE
19
50
51
When cutting larger workpiece parts to size, you can extend the cross guide
19
with
the stop rail
14
from the parallel guide
13
:
1. Screw the wing nuts
41
including the washers off of the parallel guide
13
.
22
41
19
14
14
13
41
2. Pull the stop rail
14
off of the parallel guide
13
and also remove the long car-
riage bolts and the metal plate. Store the long carriage bolts in a safe place.
3. Screw the metal plate with two carriage bolts
22
and the wing nuts
41
along
with the washers loosely onto the cross guide.
4. Turn the stop rail
14
to the desired position: upright for thick material (work-
piece thickness over 25 mm) and flat for thin material (workpiece thickness under
25 mm).
5. Push the stop rail onto the cross guide
19
, so that the metal plate glides into the
profile of the stop rail.
6. Turn the wing nuts
41
until tight again.
NOTICE!
Do not push the stop rail
14
too far towards the saw blade. There should be approx.
2 cm of space between the stop rail and saw blade.
