Operation
34
GB
After SAleS Support
34
IRE
0044 151 649 1500
0044 1890 946 244
GB
IRE
Sawing
NOTICE!
− Each time after making a new setting, perform a test cut to check the set dimensions.
− After switching on the saw, wait until the saw blade has reached its maximum
speed before you perform the cut.
− Attention when cutting into the workpiece!
− Only operate the device with an extractor device.
− Check and clean the suction channels regularly.
Performing lengthwise cuts
For this you cut through a workpiece lengthwise. Push an edge of the workpiece
against the parallel guide
13
with the flat side on the saw table.
− When making lengthwise cuts, you must never be positioned in line with the
cutting line.
− Secure long workpieces so that they do not tip over at the end of the cut! Use e.g.
a roller stand for this.
1. Adjust the parallel guide
13
to the workpiece height and the desired width
(see section “Parallel guide”).
2. Lower the protective hood
17
onto the saw table.
The protective hood is pushed up by the workpiece while sawing.
3. Switch on the dust collector first and then the saw.
4. With your fingers closed, place your hands flat on the workpiece and push it along
the parallel guide into the saw blade.
5. Only guide it laterally to the front edge of the protective hood
17
with your left or
right hand (depending on the position of the parallel guide).
6. Always push the workpiece up to the end of the splitting wedge
18
.
7. Switch the saw and the dust extractor off.
8. Let the cutting waste rest on the saw table until the saw blade returns to the rest-
ing position.
