14
AFTER SALES SUPPORT
www.einhell.co.uk
t
0044 151 649 1500
0044 1890 946 244
IRE
WAC 3050/1
03/2015
Fitting the air filter
Remove the transportation cover with a screwdriver or similar and screw
the air filter (11) securely to the device (Fig. J).
Assemble the equipment completely before you put it into operation for
the first time.
Setting up the compressor
Set up the compressor in an adequately ventilated place away from at-
mospheric influences on a level surface or one that is inclined by no more
than 10° (Fig. B). Do not set it up in areas where there is a risk of explosion.
If the surface is inclined and smooth, it must be ensured that the com-
pressor cannot move out of position during operation. If a board or shelf
is used as a base, it must be fixed according to instructions to ensure that
the device cannot fall down. To ensure adequate ventilation and effective
cooling, the distance between compressor and walls must be at least
100 cm.
Transporting the compressor
Switch off the device and pull the plug before transporting the
device.
Lift the compressor by the handle (2) in order to transport it and push or
pull it into the required position. If moving the compressor to another lo-
cation, it is best carried by two people using both handles (2, 16).
Make sure that the compressor is transported in accordance with
instructions. Do not turn it over and do not lift it with the help of
hooks or ropes.
Topping up the compressor oil
The crankcase has capacity for 300 ml of oil. To replenish the oil, remove
the oil sealing plug (12) from the oil filler opening. The oil level can be
read on the window in the bottom of the crankcase. The crankcase must
be filled with oil up to the red marker (Fig. I). Then replace the oil sealing
plug.
WAC_3050_1_EX_GB_SPK7.indb 14
16.10.14 11:34
