Worksaver HPD-16 HSS, Owner'S And Operator'S Manual, Page: 7 / 42

6
SAFETY INSTRUCTIONS
(continued)
OPERATIONAL SAFETY
Never operate the power unit and post driver until you have read and completely understand this manual, the
power unit operator’s manual, and each of the safety messages found on the safety signs on the power unit and
post driver.
The use of this equipment is subject to certain hazards which cannot be protected against by mechanical
means or product design. All operators of this equipment must read and understand this entire manual, pay-
ing particular attention to safety and operating instructions, prior to using. If there is something in this manual
you do not understand, ask your supervisor, or your dealer, to explain it to you.
Know your controls and how to stop the power unit and engine quickly in an emergency. READ THIS MANUAL
AND THE ONE PROVIDED WITH YOUR POWER UNIT.
Start power unit only when properly seated in the operator’s seat. Starting a power unit in gear can result in
injury or death. Do not mount or dismount the power unit while moving. Mount or dismount the power unit only
when the power unit and all moving parts are completely stopped.
Do not allow riders on the driver or power unit at any time. There is no safe place for any riders.
Do not walk or work under a raised driver ram unless it is securely blocked or held in position. Do not depend
on the tractor hydraulic system to hold the driver ram in place.
Never leave post driver ram in the raised position. Always lower ram to the ground or to the transport position
and install the transport lock pin before transporting or storing.
Do not operate post driver on steep hillsides. When installing posts on uneven or hilly terrain, position the power
unit with the post driver uphill. This way if any movement of the power unit should occur, it will be away from
the post driver operator.
Never position the post by hand. Always use Post Holder Tool or Post Holder Attachment.
Watch out for low overhead electrical wires and limbs when operating or transporting the post driver. Check
clearance of doorways when entering a building.
Be sure post is cut “SQUARE” on top. Angle cut post can “KICK OUT” of driver and injure the operator.
Install transport lock pin and pin clip before transporting or storing the post driver. NEVER INSERT FINGER
IN TRANSPORT PIN HOLE TO CHECK ALIGNMENT. Finger could be sheared off if driving ram moves.
Keep hands, feet, hair, jewelry, and clothing, away from all moving parts.
Do not operate the Post Driver without all safety shields and guards in place.