2 of 8
Line of Sight | (800) 463-7731 | los.workriteergo.com
1
Remove Front and Rear Panels, Set Power Cord Aside
1.1 Remove the Front and Rear Panels from the Chassis (A) by
turning the Panel Locks a quarter turn towards the center
of the panel (inward), then pivot the panels forward to
remove.
If you have Locking Panels, unlock using the included key.
1.2 Keep the protective tape around panels and on frame
until assembly is complete to protect finish.
2
Attach Top Brackets
Attach the Left Top Bracket (B) and Right Top Bracket
(C) to Chassis (A) with the four 5/16"-18 Locknuts (D).
Threaded studs on the brackets insert through holes in
the Chassis and are held in place with the Locknuts.
Removable Panel
Locking Panel
3
Attach Lid Stops to Worksurface
Note: Build Assembly in a large, clean area on carpeting or
moving blankets to prevent damaging Worksurface and Lid.
3.1 Place Worksurface (E) and Monitor Bay Lid (F) upside down on
floor. Slide Monitor Bay Lid (F) into cutout in Worksurface (E).
3.2 Attach both Lid Stops (G) with eight #10-¾" Phillips Pan Head
Screws (H).
A
B
C
F
C
D
D
1.2
1.1
1.1
3.1
3.2
Front
Panel
Threaded
Studs
Rear
Panel
Panel
Lock
Protective
tape
Under Top Bracket
E
G
H
H
#10-¾" Phillips Pan
Head Screws
Hardware at actual size
D
5/16"-18 Serrated Flange Nut
Hardware at actual size
