Workrite Ergonomics | 800.959.9675 www.workriteergo.com
5 of 10
7.500
EQUAL SPACING
EQUAL SPACING
Position the base assembly centered left to right and 7.5"
from the front of the worksurface, making sure the legs are
parallel with the back edge of the worksurface.
Using the ⅛" drill bit, drill ¾" deep pilot holes in the four
corner locations.
Note: We recommend you mark your drill bit at ¾" to
prevent drilling too deep.
Caution: Do not drill through the worksurface!
Install four (4) #12 × ¾" Phillips pan head screws (N)
into the 4 corner locations and tighten securely.
Warning: Do not over-tighten and strip the screws
into the top!
Using the ⅛" drill bit, drill ¾" deep pilot holes in the
remaining locations in the brackets on the legs.
Install #12 × ¾" Philips pan head screws (N) into all
pilot holes and tighten securely.
ATTACH BASE ASSEMBLIES TO TOP
3.1
3.2
3.3
3.4
3.5
3
N
#12 × ¾" Phillips Pan Head
Screws
Hardware at actual size
3.1
3.5
3.4
3.2
3.3
N
N
N
N
N
Front
