6.
Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
SERVICE
a.
5.
Ensure the switch is in the off position before
inserting battery pack. Inserting the battery pack
into power tools that have the switch on invites
accidents.
BATTERY TOOL USE AND CARE
f.
g.
h.
i.
If in doubt, do not plug in the tool. Using a power
source with a voltage less than the nameplate rating is
harmful to the motor.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse. To use this tool
properly, you must observe the safety regulations, the
assembly instructions and the operating instructions to
be found in this Manual. All persons who use and
If possible, always use clamps or a vice to hold your
work piece.
Always switch off before you put the tool down.
Ensure that the lighting is adequate.
Do not put pressure on the tool, such that it slows
the motor down.
Keep the area free of tripping hazards.
Do not let anyone under 18 years to operate this
tool.
Only use accessories in good condition.
Do not touch the blade after operation. It will be very
hot.
Keep your hands away from under the workpiece.
Never use your hands to remove sawdust, chips or
waste close by the blade.
ADDITIONAL SAFETY INSTRUCTIONS
GENERAL SAFETY RULES
Exposure to noise can cause hearing loss.
Loss of control can cause personal injury.
WEAR EAR PROTECTORS.
4
binding of moving parts, breakage of parts and any
other condition that may affect the power tool’s
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
Use the power tool, and accessories in accordance
with these instructions, taking into account the
working conditions and the work to be performed.
Use of the power tool for operations different from
those intended could result in a hazardous situation.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used
with another battery pack.
Use power tools only with specifically designated
battery packs. Use of any other battery packs may
create a risk of injury and fire.
When battery pack is not in use, keep it away from
other metal objects like paper clips, coins, keys,
nails, screws, or other small metal objects that can
make a connection from one terminal to another.
Shorting the battery terminals together may cause
burns or a fire.
Under abusive conditions, liquid may be ejected
from the battery; avoid contact. If contact acciden-
tally occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from
the battery may cause irritation or burns.
b.
c.
d.
e.
Rags, cloths, cord, string and the like should never
be left around the work area.
Support the work properly.
If you are interrupted when operating the tool,
complete the process and switch off before looking
up.
Periodically check that all nuts, bolts and other
fixings are properly tightened.
When using the tool, use safety equipment including
safety glasses or shield, ear defenders, and
protective clothing including safety gloves. Wear a
dust mask if the cutting or sanding operation creates
dust.