To open the chuck jaws rotate the front section of the
chuck. Insert the drill bit between the chuck jaws and
rotate the front section in the opposite direction.
Ensure the drill bit is in the center of the chuck jaws.
Finally, firmly rotate the front chuck section in the
opposite directions. Your drill bit is now clamped in the
chuck..
CHUCK ADJUSTMENT (SEE E)
5.
(SCREW DRIVING FORCE OF YOUR DRILL DRIVER)
The torque is adjusted by rotating the torque
adjustment ring. The torque is greater when the torque
adjustment ring is set on a higher setting. The torque is
less when the torque adjustment ring is set on a lower
setting.
TORQUE ADJUSTMENT (SEE F)
6.
The LED light (9) allows you to keep a clear view under
less illuminated circumstances. To turn on the light
simply press the on/off switch. When you release the
on/off switch, the light will go out.
USING THE LED LIGHT (SEE H)
8.
When drilling into a hard smooth surface, use a center
punch to mark the desired hole location. This will
prevent the drill bit from slipping off center as the hole
is started. Hold the tool firmly and place the tip of the
bit at the point to be drilled. Depress the switch trigger
to start the tool. Move the drill bit into the workpiece,
applying only enough pressure to keep the bit rotating.
Do not force or apply side pressure to elongate a hole.
DRILLING
9.
The automatic spindle lock allows you to use it as a
regular screwdriver. You can give an extra twist to
firmly tighten a screw, loosen a very tight screw or
continue working when the battery energy has expired.
For manual screwdriver purposes, the chuck is
automatically locked when the tool is off.
AUTOMATIC SPINDLE LOCK (SEE G)
7.
1 - 4 For driving small screws
5 - 9 For driving screws into soft material
10 - 14 For driving screws into soft and hard material
15 - 19 For driving screws into hard wood
20 - 21 For driving larger screws
For heavy drilling
MAKE THE SETTING AS FOLLOWS:
E
13
1
5
1
7
19
21
RE
LE
ASE
F
13
15
17
19
21
REL
E
A
S
E
H
9
G
OPERATION
11