PH: 866.476.9217
16
X. REASSEMBLING THE IMPACTOR
Once the Impactor's internal components have been inspected, repaired or replaced,
the Impactor can be reassembled. The reassembly of the Impactor is essentially the
disassembly instructions in reverse order.
1.
Wash all parts thoroughly in fresh, clean solvent.
2.
Replace Rear Gasket
[32]
and Front Gasket
[7]
.
3.
Coat all parts with a light film of spindle oil or air tool oil.
4.
Clean and repack, with a good grade of grease, two (2) Cylinder Plate
Bearings
[25]
and Anvil Cone Bearing
[18]
.
5.
Make sure all air passages are free of any dirt or foreign matter.
6.
Grease the Impact Mechanism
[10, 12, 13, 14, 15, 16]
heavily with a high-
grade Impact Wrench Grease (MOBIL DELVAC™ Xtreme Grease, or Equal).
Be sure to coat Hammer Cage Assembly completely and coat the inside wall
of Hammer Casing
[1]
w/ a thick coating of grease as well.
7.
After the Impactor has been assembled, pour 2 oz. (6-8 squirts) of TOOL-
LUBE air tool oil (supplied) in the Air Inlet to ensure immediate lubrication of
the complete tool.
IMPORTANT
Refer to Section XI: Impactor Exploded View
during reassembly.
IMPORTANT
DO NOT "pack" grease into Impact Section of
Wrench. All parts must be coated in grease, but
also able to move freely. "Packed" grease will
inhibit free movement of components.
Summary of Contents for GO-A8-PW
Page 1: ...GO A8 PW Gate Opener MAINTENANCE PARTS MANUAL...
Page 22: ...PH 866 476 9217 18 XI IMPACTOR EXPLODED VIEW...
Page 31: ...NOTES...