Set the squeegee and flood bar pressure after setting the proper angle to avoid damage to the screen mesh
1. Push down on the pressure adjust knobs to ensure the flood bar is not contacting the mesh.
2. Adjust pressure knobs to maintain a gap of .008” between the flood bar and the mesh.
3. Test the flood and adjust accordingly.
4. Pull the carriage forward to confirm the screen is flooded properly.
5. If the angle of the squeegee has changed, the flood bar pressure will also have changed. Review the flood
bar pressure to avoid tearing the screen mesh.
To add or remove pressure, turn the black knob on top of the
chopper cylinders. Turning the knob clockwise will lower the
gap, shorten the stroke, and reduce the pressure applied.
.008 Gap
3730 E. Southern Avenue, Phoenix, AZ 85040 USA
800-778-8779
Workhorseproducts.com
26
Squeegee and Flood bar
