23
OPERATION
ON/OFF switch
1.
Start the machine by pressing the I button of the ON/OFF switch (17).
2.
Before using the machine let the wheel reach full speed. Wait also for the cooling water
pump (14) to pump water to the cutting disc.
3.
Switch off the machine by pressing the O button of the switch (17).
90° cutting
1.
Loosen the wing bolt (C).
2.
Set angled stop (6) to 90
˚
and tighten the wing
bolt (C) again.
3.
Tighten the wing bolt (D) to fix the angled stop.
4.
Push the machine head (1) towards the rear by
the handle (11).
5.
Place the tile on the stop rail (7) at the angled
stop (6).
6.
Start the machine.
7.
Caution: Wait for the cooling water to reach the
cutting disc (10).
8.
Push the machine head (1) slowly and evenly by
the handle (11) forward through the tile.
9.
Switch the machine off after reaching the end.
45° diagonal cutting
1.
Set angled stop (6) to 45°.
2.
Carry out cutting as described above.
45° longitudinal cutting
1.
Loosen the star knob screw (E) on both sides.
2.
Slant guide rail (8) at the left to 45
˚
of the angle
scale (18).
3.
Tighten the knob screw (E) again.
4.
Carry out cutting as described above.
