22
PRIOR TO USE
SPECIFIC SAFETY INSTRUCTIONS
-
Place the machine on a solid and slide-proof surface.
-
Check all the protection and safety devices before use.
-
Check that the diamond cutting wheel is intact and can rotate freely. Do not use a worn or
defect wheel.
-
Check that the voltage on the nameplate matches the existing voltage.
-
Check that there is enough water in the tub so that the cooling water pump is under water
and that the wheel does not touch the hose or cord.
-
Use only recommended diamond cutting wheels for wet saw.
-
Always saw towards the stop.
-
Do not use any object to make the wheel stop faster. Let it slow down itself!
-
Unplug the machine always after use.
-
Even if the machine is used according to the manual some residual risks remain. Be aware of
them and try to avoid them.
-
Thrown objects and splashes can cause a danger. Wear safety goggles.
-
Risk of hearing impairment. Wear ear protection.
-
Risk of injury to fingers and hands. Wear protective gloves.
-
Risk of injury to fingers and hands. Keep hands and other parts of your body at a
distance of at least 10 cm from the rotating wheel.
Assembly
For technical packaging reasons, your machine is not
fully assembled.
1.
Take the machine out of the packaging and place it
on the floor very carefully. If any part is missing or
damaged, contact your dealer immediately.
Dispose all packing material according to local
regulations.
2.
Introduce the legs (3) into the base frame and fix
them with butterfly nuts (Fig. 3, A).
3.
Set the machine on its legs.
4.
Install the handle with 2 cross-recess screws (Fig. 4,
B) on the motor casing.
Note:
The handle can also
be mounted on the opposite side.
5.
Place the tub (4) in the base frame (2).
6.
Place the cooling water pump (14) in the tub (4).
7.
Fill with water until the pump (14) is completely
filled with water (Fig. 4)
8.
Pull out the pin of the transport lock (Fig. 5, 13).
