30
90
˚
angle
-
Release the angle arrester (1) and move the cutting head to the very right. Lock the angle
arrester.
-
Utilize the protractor for setting the angle of the saw blade to 90° to the table. If a cali-
bration is necessary turn the screw (2) with the provided Allen key in a way that the saw
blade reaches 90° to the table.
-
Set the angel indication (3) to 0° using the screw.
45
˚
angle
-
For setting the angular stop to 45° move the cutting head to the left and adjust the screw
(4) with the Allen key until the 45° position on the scale (3) is reached.
Adjusting the fence
Lower the cutting head and push in the lock pin. Make sure the table is in 0° mitre position.
Place a combination square against the fence and next to the saw blade. If the blade does
not contact the square, loosen the screws. Adjust the fence so that the fence has full contact
with the square. Tighten the screws.
Calibrating the laser line
-
In order to calibrate the laser beam use a shelf (approx. 200 mm x 300 mm). Mark a right
angle line and put the shelf onto the bearing surface of the table.
-
Align the marking centred to the saw blade and lock it with the clamping shoe.
-
Turn on the laser using the ON/OFF switch.
-
In order to calibrate the laser line, release the two slotted screws (1). Now move the laser
unit until the laser line matches the marked line. Note: You can calibrate the laser line to
be running at the side or in the middle of the cut.
-
Tighten the slotted screws again and recalibrate them as and when required.