31
TROUBLESHOOTING
Problem
Cause
Solution
Engine fails to
start.
-
Overload protection de-
vice disengaged.
-
Contact a qualified electrician
to engage the device.
Fails to split
logs.
-
Log is improperly posi-
tioned.
-
Log size or hardness ex-
ceeds the capacity of the
machine.
-
Wedge cutting edge is
blunt.
-
Oil leaks.
-
Unauthorized adjustment
was made on maximum
pressure limiting screw.
Lower pressure limit was
set.
-
Place the log correctly.
-
Check the size and hardness
of the logs to match the ma-
chine capacity.
-
Sharpen the wedge.
-
Locate the leaks and contact
your dealer.
-
Contact your dealer.
The log pusher
moves jerkily,
making unusual
noise or vibrat-
ing.
-
Low hydraulic oil level and
air in the hydraulic sys-
tem.
-
Check the oil level and refill if
needed.
Oil leaks.
-
Air in the hydraulic sys-
tem.
-
Air bleed screw has not
been tightened before
moving the machine.
-
Oil draining plug is not
properly closed.
-
Hydraulic control valve
assembly or seal(s) worn.
-
Loosen the bleed screw by
some rotations before operat-
ing the log splitter.
-
Tighten the bleed screw before
moving the machine.
-
Tighten the oil drain plug.
-
Contact your dealer.
