-25-
Model W1888 (For Machines Mfd. Since 10/20)
SE
TU
P
14.
Attach rear rail to main table using (2) M10-1.5 x
25 hex bolts, 10mm lock washers, and 10mm flat
washers, as shown in
Figure.24
. Check to make sure
rear rail is parallel to table and below miter slots
before completely tightening hex bolts.
15.
Secure rear rail to extension wings with (2) M10-1.5
x 35 hex bolts, (4) 10mm flat washers, (2) 10mm
lock washers, and (2) M10-1.5 hex nuts (see
Figure.
24
).
Figure.24.
Rear rail installed.
x 2
x 2
16.
Attach switch to bottom left-hand side of front
rail using (2) M6-1 x 15 flat head screws, 6mm lock
washers, 6mm flat washers, and M6-1 hex nuts (see
Figure.25
).
17..
Attach dust hose support arm to rear rail with M6-1
hex nut, 6mm flat washer, 6mm lock washer, and
M6-1 wing nut. Orient arm so open end of hook faces
outward (see
Figure.26
).
Figure.25.
Switch box installed.
Figure.26.
Dust hose support installed.
Open End
Faces
Outward
Dust Hose
Support
Rear Rail
x 2
Summary of Contents for Shop Fox W1888
Page 97: ......
