-23-
Model W1888 (For Machines Mfd. Since 10/20)
SE
TU
P
5.
Remove switch from inside saw cabinet, and install
motor door by inserting door pins into hinge sockets
on cabinet (see
Figure
17
).
6.
Inspect extension wings and main table (see
Figure.
18
) mating surfaces for burrs or foreign materials
that may inhibit assembly.
Note:
For a correct fit, mating edges of table and
wings must be clean, smooth, and flat. If necessary,
use a wire brush or file to remove any flashing,
dings or high spots.
7.
While
an assistant holds wings in place, attach each
extension wing to main table with (3) M10-1.5 x
30 cap screws, 10mm lock washers, and 10mm flat
washers (see
Figure.18
).
8..
Place straightedge across extension wings and main
table to make sure that combined table surface is
flat.
— If combined table surface is flat, skip to next step.
— If outside end of extension wing tilts down, place
a strip of masking tape along bottom edge of main
table to shim end of extension wing up (see
Figure.
19
).
Figure.17.
Motor door installed.
Figure.18.
Extension wings installed.
x 3
Figure.19.
Masking tape location for tilting
extension wing up.
Figure.20.
Masking tape location for tilting
extension wing down.
Hinge Socket
— If outside end of extension wing tilts up, place
strip of masking tape along top edge of main table
to shim end of extension wing down (see
Figure.
20
).
Note:
After installing wings, remove all excess
masking tape with a razor blade.
Summary of Contents for Shop Fox W1888
Page 97: ......
