Woodstock Shop Fox W1888, Owner'S Manual

Page: 20 / 97

-17-
Model W1888 (For Machines Mfd. Since 10/20)
SE
TU
P
Box.Contents.(Figures.9–11)...............................Qty
A.
Main Table Saw Unit .......................................1
B. Extension Wings ............................................2
C.
Saw Blade 10" x 40T .......................................1
D. Motor Door ..................................................1
E.
Arbor Wrench 13/27mm ..................................1
F. Dado Table Insert ..........................................1
G.
Blade Guard Dust Port ....................................1
H. Blade Guard Assembly ....................................1
I.
Hex Wrench 6-Piece Set 2.5-8mm ......................1
J. Riving Knife .................................................1
K.
Miter Gauge ................................................1
L. Dust Hose Adapters ........................................2
M.
Push Stick ...................................................1
N. Dado Blade Arbor Flange .................................1
O.
Dust Port 4" .................................................1
P. Handwheels .................................................2
Q.
Handwheel Lock Knobs ...................................2
R. Handwheel Handles .......................................2
S.
Dust Hose 94" x 1
1
⁄
2
" ......................................1
T. Hose Support Arm .........................................1
U.
Dust Hose 3" x 26" .........................................1
V. Hose Clamp 3
1
⁄
4
" ..........................................1
W.
Cabinet Access Door ......................................1
X. Door Latch ..................................................1
—Phillips Head Screws
8
⁄
32
" x
3
⁄
8
" .......................2
—Hex Nuts
8
⁄
32
".............................................2
Y.
Hinge Pins ...................................................2
Inventory
Figure.9. Main table saw unit.
A
Figure.10.
Extension wings.
B
The following is a list of items shipped with your machine.
Before beginning setup, lay these items out and inventory
them.
Note: If you cannot find an item on this list, carefully
check around/inside the machine and packaging materials.
Often, these items get lost in packaging materials while
unpacking or they are pre-installed at the factory.
Figure.11..
Component inventory.
H
O
P
Q
R
S
T
I
J
K
L
M
N
C D
E
F
G
X
U
V
W
Y