Woodstock Shop Fox W1669, Instruction Manual, Page: 24 / 44

Use
Figure.37.
to select the optimum motor-to-spindle pulley ratio for drilling, cutting, and sanding
operations. for example the above figure shows the belt in the C position on the spindle pulley and the
#3 position on the motor pulley, which will give a speed of 1,520 RPM. Refer to the
Drill,.Cutter,.and.
Saw.RPM.Chart
on
Page.23
for suggested tool RPMs.
Figure.37.. Drill Press RPM Chart.
Drill.Press.RPM.Chart
Drilling.Depth
Your new drill press comes fitted with a depth
stop that allows drilling many holes at a pre-
set depth consistently. When the hex nuts are
set, the nuts will contact the stop flange and
stop the drill press from drilling any deeper.
To.adjust.the.drilling.depth,.do.these.steps:
1. Measure the maximum depth that you want
to drill a series of holes at. In this example
the maximum depth is 1
1
⁄
4
" deep.
2. Loosen the hex nuts shown on the depth
stop and align the lower nut to the 1
1
⁄
4
"
mark on the depth stop rod (see Figure.
38
).
3.
Hold the lower hex nut and tighten the
upper hex nut so both nuts are locked
together.
4.
Make sure the depth has been set cor-
rectly, measure, or drill a hole into scrap
wood before drilling into any workpiece.
Figure.38.. Depth stop set for 1
1
⁄
4
" drilling
depth.
Depth..
Stop
Upper
Hex Nut
Stop.
Flange
Lower.
Hex.Nut
1-1⁄4
"
OPERATIONS
-22-