-17-
OPERATIONS
Once assembly is complete and adjustments are
done to your satisfaction, you are ready to test
run the machine.
Make sure the starting switch is off. The pad-
dle is in the down position when off. Make
sure all the fasteners and bag clamps are tight.
Plug in the power cord. Pull the START paddle.
Make sure that your finger is poised over the
paddle, as in
Figure 25,
just in case there is a
problem. The Dust Collector should run smooth-
ly, with little or no vibration or rubbing noises.
Strange or unnatural noises require that you turn
off the machine, wait for it to stop moving,
unplug the machine, investigate and correct the
problem before further operation.
If the source of an unusual noise or vibration is
not readily apparent, contact our service
department for help at 1-360-734-3482 or via
[email protected].
Test Run
Bag Changes
DO NOT investigate or
adjust the machine while
it is running or moving.
Wait until the machine is
turned off, unplugged
and all working parts
have come to a stop
before proceeding!
Always wear a dusk mask
when removing and
installing bags. Failure
to do this will risk good
health.
Figure 25.
Hand poised over stop paddle.
Always wear safety glass-
es when operating Dust
Collector. Failure to
comply may result in
serious personal injury.
The lower bag on the dust collector should be
emptied when it becomes
2
⁄
3
to
3
⁄
4
full.
1.
Always wear a dust mask when removing
and installing dust collection bags.
2.
Shake the upper bag and let the dust inside
settle for a few minutes.
3.
Loosen the latch clamp holding the bag.
4.
Take the bag off of the collector body and
close up the opening.
5.
Place a garbage bag over the opening of the
collection bag. Invert both bags to empty.
Summary of Contents for G9975
Page 21: ... 20 ...
Page 23: ... 22 ...
