Woodstock G9975, Instruction Manual

Page: 16 / 25

-15-
A transfer hose connects the collector body with
the separator using 2 wire hose clamps.
1. Slide a wire hose clamp onto the end of the
transfer hose.
2. Slide the transfer hose end over the inlet for
the separator making sure end passes the
ridge on the inlet by 1
1
⁄
2
".
3. Position hose clamp over hose and inlet
making sure clamp is
3 ⁄
4
" from end of hose
and tighten screw on clamp. See Figure 20.
4. Slide the second hose clamp onto free end
of hose.
5. Slide end of transfer hose onto outlet of the
collector body. Hose should go on as far as
possible.
6. Slide hose clamp within
3
⁄
4
" of the end of
hose and tighten screw on clamp.
Transfer Hose
Figure 20. Securing hose with clamp.
A 4" inlet is supplied with your Shop Fox
®
dust
collector. It is sized for connecting one or two 4"
flexible hose(s). One or both of the openings
may be used and a cap is included to block off
air, if needed. The opening on the collector
body is 5" and may be used in conjunction with
5" ducting. To use the 4" inlet, follow the
instructions below.
1. Slide inlet onto 5" opening on the face of
the collector body.
2.
Secure inlet with sheet metal screws.
See
Figure 21.
4" Inlet
Figure 21. Securing inlet with screw.
Do Not remove inlet grat-
ing. If large debris should
come into contact with
the impeller, serious
injury may occur.