------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ 13
--------------------------------------------------------------------------------------------------------------------
Pre-Installation Inspection Checklist for Installer
Remove Packaging
1. There is a corrugated carton packed on the front skirt of the
Fireplace. The corrugated box contains the ceramic logset and
two brass finials. Remove the carton and set it aside.
2. Use a phillips screw driver to remove the eight screws that
attach the four metal straps to the shipping pallet.
3. Lift the Fireplace straight up off the pallet by hand, being
careful not to damage the controls and wiring that are under
and at the back of the Fireplace. The Fireplace is heavy. You
will need 3 people to lift it.
4. Using a 1/2” socket, remove the four metal straps from the
bottom of the stove.
Packing List
A. Owners Manual (packed on top of Fireplace)
B. Corrugated box containing:
1. Log set (handle the log set with care; the ceramic logs
are fragile)
2. Two brass finials
1. Check that both intake and exhaust venting are clear of any
debris or other obstruction at the back of the Fireplace.
2. Check that the gas manifold is connected to both the
controller and the orifice at the back wall of the Fireplace
(see illustration 9.1).
3. Remove the Front Casting (see illustration 9.1).
4. Remove the foam wedges used to keep the Pressure Relief
Lids in place (see illustration 9.2).
5. Remove the Glass Front (see illustration 9.3).
6. Check that the Pressure relief Lids are both seated flat (see
illustration 10.2)
7. Check that the thermopile connector, pilot gas tube, and
8. UNPACKING THE FIREPLACE
Illustration 8.1
There are four straps
that hold the Fireplace to the pallet
during transport. Before lifting the
Fireplace off the pallet, you must detach
the metal straps from the pallet. Remove
the four screws using a phillips screw
driver. There are two straps at the rear
of the stove and one on each side.
9. PRE-INSTALLATION INSPECTION
CHECKLIST FOR INSTALLER
Illustration 9.1
To remove the front
casting, lift straight up under the
two sets of star decorations and
then gently pull the bottom out.
Corrugated box
Illustration 8.2
Remove corrugated
box .
Gas
Manifold
