Assembly
41
MAN1248 (2/26/2018)
Gage Wheel (Optional)
(See Figure 37)
Gage wheel is applied to right (and optionally the left)
side of 5 or 6 foot deck.
1.
Remove tab from right (left) side of deck side frame
as shown.
2.
Using four 1/2" fastener sets, attach gage wheel to
side of deck as shown.
3.
Adjust wheel height up or down 2" by relocating
axle into provided holes.
Figure 37
. Gage Wheel Installation
Cooler Installation (Optional)
(See Figures 38 & 39)
Cooler option is an available upgrade designed to keep
hydraulic oil below 170°F during heavy cutting. Cooler
option mounts to the implement and draws electric
power from the tractor 7 way plug. Fusing for 17 amp
draw is necessary. Cooler crate option is sold under
part number 1041830CRT.
NOTE:
For this instruction, Right and Left are estab
-
lished facing the tank inlet.
1.
Draining the tank is not necessary but precautions
should be taken to capture a small amount of
hydraulic oil.
2.
Unclamp the hose from motor at the hose support
above the gearbox.
3.
Loosen JIC of bypass hose connection at the
bypass valve and remove from tee.
4.
Remove JIC of tee at filter. Hose from motor to stay
with tee.
5.
Remove fasteners of filter bracket at tank and filter.
Retain fasteners, discard bracket.
6.
Remove filter with adapter (right) and tee (left) from
tank. Tee is pipe threaded.
7.
Remove tee from filter and plug from tee. Discard
plug.
Figure 38
. Cooler Pre-Installation
8.
Attach JIC tee with hose to filter at adapter (right)
as shown. Keep connection loose.
9.
Attach tee (15) to tank. Use teflon tape on all male
pipe threads. Tighten tee so hat run is vertical as
shown.
10.
Attach pipe (13) below and adapter (20) above as
shown. Tighten.
11.
Attach elbow (14) to pipe below and valve (17) as
shown. Tighten so that valve points away from
tank.
12.
Attach elbow (14) to valve and pipe (13) above as
shown. Tighten so that pipe is pointing upwards.
13.
Attach tee (16) from step 6 to pipe and adapter (20)
above. Tighten so that branch points right.
14.
Attach filter from step 7 to tee (16).
15.
Attach hose from step 4 to filter at adapter.
16.
Attach bracket (8) using fasteners from step 5 to
tank and filter.
17.
Loosely attach brackets (9) to tank using fasteners
(2 & 3).
18.
Attach adapters (12) to cooler (7) as shown.
Tighten.
1.
1/2 NC x 1-1/2 Carriage bolt, GR5
2.
1/2 NC flange lock nut
