Rev 0.0/7-12
21
MR1611LDCO/DVS: #35048
V
ACUUM
P
AD
M
AINTENANCE
Friction Coefficient
The friction coefficient represents the lifter's ability to resist load slippage when the load is
oriented in any position except horizontal. If the contact surfaces of either the load or the
vacuum pads are not clean, dry and in good condition, slippage is more likely to occur.
The Load Capacity of most Powr-Grip lifters is based on a friction coefficient of 1 (only Flat Lifters
are exempt from this requirement). However, a vacuum pad's ability to maintain this friction
coefficient is reduced by factors such as contamination, wear, age and exposure to sunlight, as
well as the condition of the load's contact surface (see INTENDED USE: L
OAD
C
HARACTERISTICS
).
Pads that have surface contamination must be thoroughly cleaned (see Cleaning discussion to
follow). Over time, the rubber in a pad may experience hardening or leaching of chemicals,
resulting in stiffness or surface glaze. Pads that exhibit wear, stiffness or glaze must be replaced.
In addition, all pads should be replaced on a regular basis, preferably after no more than 2 years,
to ensure that the friction coefficient is not compromised. If necessary, contact your dealer or
Wood's Powr-Grip for more information.
Inspection
Inspect each vacuum pad for the following deficiencies routinely, as directed in the preceding
I
NSPECTION
and T
ESTING
S
CHEDULES
. Correct any deficiency before using the lifter.
• Contaminates on the pad face or sealing edges: Soil build-up can prevent pads from sealing
adequately or reduce the friction coefficient (see discussion preceding). Follow the directions
to clean pads as necessary (see discussion to follow).
• Filter screen missing from pad face: This screen helps prevent debris from plugging the
vacuum hose and the air filter. Replace any missing screen immediately (see REPLACEMENT
PARTS LIST).
• Nicks, cuts or abrasions in sealing edges: Pad damage can reduce the lifting capacity. Replace
any damaged pad immediately (see REPLACEMENT PARTS LIST).
WARNING: Replace vacuum pad if sealing edge has any nicks, cuts or abrasions.
• Wear, stiffness or glaze: See Friction Coefficient preceding. Replace any pad that exhibits
wear, stiffness or glaze (see REPLACEMENT PARTS LIST).
Cleaning
Regularly clean the face of each vacuum pad to remove oil, dust and any other contaminates.
Acceptable cleaning agents include soapy water and other mild cleansers. Do
not use solvents,
petroleum-based products (including kerosene, gasoline and diesel fuel) or any harsh chemicals
for cleaning. Do
not use unauthorized rubber cleaners or conditioners, such as those intended
for cleaning tires or vinyl surfaces, because those products can leave a hazardous film on vacuum
pads which significantly reduces their lifting capacity (see Friction Coefficient preceding). The
use of any unauthorized cleaning agent is prohibited because it could damage the pad and/or
create a hazard to the operator or others.
WARNING: Never use solvents, gasoline or other harsh chemicals to clean
vacuum pad.
Summary of Contents for MANUAL ROTATOR 2800
Page 2: ......
