2
5
6
7
For parts less than 1-1/4” thick, attach the Toggle Clamps
(in 6305IC bag)
directly to the center T-slot of the
Fence using the 3/8” screws
(MP375 x2 per clamp)
and offset oval
nuts
(5765B x2 per clamp)
.
For parts 1-1/4” to
1-3/4” thick, elevate
the Toggle Clamps
1/2” above the Fence
using hardware
included in the Inboard
Clamp Hardware
(6305IC)
.
Insert two 1” bolts
(HB030)
in the rear T-slot
in the Fence, then a 5/8” spacer
(BUSH004)
and handle
(5590)
on the end of each bolt.
Position the handles in the bottom corners
of the Fence and tighten.
Insert a 1” bolt
(HB030)
thru the hole near each end of the miter slot in the Horizontal Router Table. Install a washer
(WS002)
and a 2” T-knob
(5548)
on each bolt on the underside of the table. Slide a 6” One Track
(4206)
onto
the head of
each bolt, position them where desired to control travel of the Mortise Table/length of the mortise and tighten the knobs.
WS002
& 5548
HB030
HB030
BUSH004
& 5590
MP375 &
5765B
