Woodbridge BJ100, Installation And Care Manual

Page: 8 / 12

R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
8
Air Blower ON/OFF
Wave Massage ON/OFF
Thermostate
Bottom light ON/OFF
Power ON/OFF switch
Display Window
4. Schematic diagram of the panel
BJ400
(1) Press the Power switch , to turn on the power.
(2) Press the Bottom Light , switch to turn on and off the lights.
(3) Press the Air Blower , to turn on and off the air blower.
(4) Press the Wave massage , switch to activate the whirlpool feature, repeat the same operation to
end the feature.
(5) With sufficient water inside the tub, press water pump switch then press thermostat , switch to
turn on the heater, repeat the same operation to turn off thermostat function.
(6) Under thermostat cycle, long press Thermostat switch to get into water temperature setting mode,
When Thermostat icon blinking, continue to press till desired temperature then release, blinking will
continue for few seconds then stop and temperature display will show current water temperature.
When setting temperature is reach, heater will automatically stop running but when water get colder
and is below the setting temperature, the motor will resume and operating.
** DO NOT Power on the water pup if there is no enough water inside the tub.
** The setting temperature range is between 86˚ F to 122 ˚ F (30 ˚ C – 50 ˚C)