Fire Deck
Service Manual
PG
39
OF
44
M0011.09 APRIL 2019
An ongoing program of product improvement may
require us to change specifications without notice.
WOOD STONE CORPORATION
1801 W. Bakerview Rd.
Bellingham, WA 98226 USA
TOLL FREE
800.988.8103
TEL
360.650.1111
FAX
360.650.1166
woodstone-corp.com
START-UP INFORMATION
START-UP INFORMATION
Wood Stone ovens should not normally require any start-up procedures to be performed by a service technician�
The gas installer is responsible for making sure the gas supply to the oven is properly purged (bled) and that the piping and pressure
is adequate for the BTU/hr requirements of the oven� Burner gas pressures are preset at the factory�
The electrical connection to the oven should be made by a licensed electrician�
A Wood Stone representative may be available to visit the site to verify that the oven is functioning correctly and address any
questions the customer may have�
We do understand that in some situations a customer may request a service technician to perform an additional start-up on the oven
for peace of mind, etc� Typically this additional start-up will not be covered by Wood Stone, unless it was necessary due to a defect
on the oven itself� Problems arising from improper installation will be the owner’s responsibility� See the complete warranty in this
manual� It can also be found in the Installation and Operation Manual� Please call the factory if you have any questions�
