FD-6045-CE and FD-8645-CE
Fire Deck Installation and Operation Manual
PG
21
OF
32
M0042.13 JULY 2019
DAILY MAINTENANCE
OVEN INTERIOR
Wood Stone recommends the use of long-handled brushes for sweeping up surface debris that will accumulate on the floor of
the oven during use� Use a natural fiber brush—always brushing away from the radiant burner wells� For deeper cleaning, use a
brass bristled brush� The oven floor can be then cleaned with a damp rag wrapped around the brush head�
Wood Stone offers an assortment of oven brushes available through your local distributor� Specification sheets may be viewed on
the Wood Stone website under Tools & Accessories�
DO NOT USE ICE OR EXCESSIVE WATER ON THE FLOOR. THIS IS TO PREVENT THERMAL SHOCKING OF THE STONE.
There are stainless steel burner guards to prevent food from falling on and thereby obstructing the gas orifices of the radiant
flame�
If debris gets into the radiant flame well or the flame is visibly obstructed, turn the oven OFF immediately and
call for service
�
OVEN EXTERIOR
All painted and stainless steel surfaces should be cleaned as necessary using an approved mild detergent, hot water and a
soft cloth or sponge� Stubborn residues may be removed using a nonmetallic scouring pad�
When scouring stainless steel
surfaces, scrub with the grain of the metal to prevent scratching.
IMPORTANT:
Do not use excessive amounts of liquid when wiping on or around the controller box.
MAKE SURE THE TOP OF THE OVEN IS KEPT CLEAR AND THAT ANY GREASE CATCHES OR HOODS ARE CLEANED
FREQUENTLY. DO NOT ALLOW GREASE TO ACCUMULATE ON TOP OF THE OVEN.
DO NOT USE THE RADIANT BURNER WELL AS A DUMP FOR DEBRIS OR TRASH INCINERATION; MAKE EVERY
ATTEMPT TO KEEP DEBRIS FROM DROPPING INTO THE WELL.
CLEANING THE HEAT SHIELD DOOR
The glass heat shield is designed to allow for easy cleaning�
It should be cleaned daily.
The front of the heat shield can be
cleaned in the lowered position using a soft cloth and mild soap and water solution�
To clean the back of the glass, first raise the shield to its up position� The shield can then be rotated up and over the roller blocks,
which will support the shield in this position, allowing the back to be cleaned� Rotate back to the normal position for normal
operation�
CAUTION:
Do not use abrasive pads, which may etch or fog the glass� Avoid excessive water� Prevent dripping onto the ceramic
hearth of the oven by placing sheet pans in the doorway to catch drips�
For excessive build up on glass, oven cleaner may be used on an
infrequent
basis� Take
extreme
care to prevent dripping onto
the ceramic hearth by placing sheet pans in the doorway to catch drips�
