Setup and Operation
One-person operation
Setup and Operation
doc011422
3-3
3
See Figure 3-1.
7.
Remove the pass back bars from the table top by unpinning them and slide them out.
8.
Momentarily (approximately 15 seconds) run the blade on the drive wheels.
9.
Turn off disconnect.
10.
Open the wheel covers to inspect the blade tracking.
NOTE:
If the blade is not tracking in the center of the tire, refer to
Section 4.2 Tracking the blade.
11.
When the blade is tracking properly, close the wheel covers and turn on the disconnect.
12.
Start the blade.
FIG. 3-1
DM200-03
Tension ratchet
handle
Stop bolt