SETUP & OPERATION
Oil Flow Adjustment
2
2-13
ISHdoc063008
SETUP & OPERATION
2.9
Oil Flow Adjustment
To activate blade oiling, open the oil flow control valve located on the oiler.
2.10 Feed Rate Adjustment
The Feed Rate Dial controls cam speed. During the sharpening cycle, adjust cam speed
to have as fast of a feed rate as possible without "burning" the blade.
NOTE:
All machines should be adjusted by maintenance to a maximum speed of 60
revolutions per minute.
2.11 Magnetic Shut-off
See Figure 2-10.
The shut-off sensor is located to the right of the blade clamp assembly.
When passed over by a magnet, it automatically shuts down the grinder and cam motors.
To install, take an orange-painted magnet from the bag assembly. Place the black side
of the magnet against the bottom edge of the blade on the inside of the tenth face-ground
tooth. After the sensor bracket has shut off the cam and grinder motors, flip the grinder
switch into the off position. Remove the magnet.
FIG. 2-10
