SETUP & OPERATION
Sharpener Alignment
SETUP & OPERATION
ISHdoc063008
2-4
2
2.4
Sharpener Alignment
Use the provided LTAGA-PLCBN sharpener alignment tool as necessary to achieve
accurate alignment between the blade clamp and the grinding wheel.
IMPORTANT!
Do not adjust the alignment tool bolts. They
have been pre-calibrated at the factory to ensure accurate
alignment results.
1.
IMPORTANT!
Make sure the grinder motor is OFF. Cycle the cam until the grinding wheel
is at the tip of the tooth (about to begin face grind).
2.
Remove the grinding wheel cover and sharpener arbor nut. Dismount the oiler. Remove
the grinding wheel.
3.
Remove the blade rest bolts and moving clamp plate.
4.
Install the alignment tool to the grinder motor shaft as shown below.
See Figure 2-3.
Position the tool so all three gauge points are in line with the front clamp
plate. Secure the tool in position with the sharpener arbor nut.
5.
Loosen the clamp adjustment bolts.
FIG. 2-3
CBNSH08C
Alignment
Tool
