Sawmill Setup
Portable Sawmill Setup
3
3-5
50HD07doc072310
Sawmill Setup
See Figure 3-3.
For Fine Adjust Outriggers (FAOs), lower the outrigger as close to the
ground as possible, then secure in place with the locking pin. Adjust the outrigger base so
that it contacts the ground. To adjust, use the provided wrench to turn the height adjust-
ment nut. Turn clockwise to lower. Turn counterclockwise to raise. Maximum adjustment
available is 1 1/2” (3.8 cm).
CAUTION!
Do not adjust the FAO outrigger base height
while there is weight on the FAO. Damage to the FAO may
result.
3.
Use the up/down on the control box to raise the cutting head from the carriage rest pin.
Remove the locking pin and swing the rest pin down below bed level.
CAUTION!
Always make sure the engine is running before
operating the sawmill controls. Operating the controls with-
out the engine running will result in power drainage from
the battery.
4.
Remove the fenders by lifting them out of the slots.
CAUTION!
To prevent fender damage, remove fenders
before operating sawmill or loading logs.
FIG. 3-3. BASE HEIGHT ADJUSTMENT (FOR FINE ADJUST OUTRIGGER ONLY).
SM0213
FAO Base
Height Adjustment Nut
Locking Pin
Provided
Adjustment Wrench
Existing
Outrigger Guide
