Sawmill Alignment
Blade Guide Arm Vertical Adjustment
Sawmill Alignment
HDSdoc041118
5-14
5
5.7
Blade Guide Arm Vertical Adjustment
1.
Move the saw head so that the blade guide arm is directly over a bed rail.
2.
Adjust the blade guide arm out to within 1/2" (15 mm) of full open.
3.
Measure from the top of the bed rail to the arm.
See Figure 5-12.
4.
Adjust the blade guide arm in to within 1/2" (15 mm) of full closed. Measure again from
the top of the bed rail to the arm.
5.
Adjust the arm so that the measurement from the top of the bed rail to the arm in the
closed position is the same as the measurement from the top of the bed rail to the arm in
the open position.
If the arm is too low in the closed position, loosen the lower outside roller and tighten the
upper outside roller (See Step 6.)
If the arm is too high in the closed position, loosen the upper outside roller and tighten the
lower outside roller (See Step 6.)
FIG. 5-12
Turn outside rollers to raise
or lower end of blade guide arm
SM0065B
