Troubleshooting Guide
Simple Set Troubleshooting (LT35)
Troubleshooting Guide
WMdoc072619
6-14
6
If there is no voltage reading:
Check the lights on the control module: the red light when in the down position and
the green light when in the up position,
If there are no lights, check for voltage at the drum switch terminals.
If the lights are working:
Check the lights on the h-bridge: the red light when in the down position and the
green light when in the up position,
If there are no lights, replace the control module.
If the lights are good:
Replace the h-bridge.
Setworks inaccuracy issues:
If the saw head comes up short of the drop, verify that there are no binds on the
mast. If it is good, replace the encoder and cable,
If the saw head goes long past the drop, verify that the up/down belt is tight. If it is
good, replace the encoder and cable.
IMPORTANT!
The PGain settings and speed values should never be changed!
