Sawmill Operation
LT30HD Rev. G6.00+ LT40HD Rev. G6.00+
Sawmill Operation
HD97doc041910
4-3
4
LT30HD Rev.
G6.00+
LT40HD Rev.
G6.00+
See Figure 4-3.
Hydraulic units have six control levers to load, clamp, turn and level logs.
Use the hydraulic control levers to get the mill ready to load a log.
DANGER!
Keep all persons out of the path of moving
equipment and logs when operating sawmill or loading and
turning logs. Failure to do so will result in serious injury.
CAUTION!
Always make sure the engine is running before
operating the hydraulic controls. Operating the controls
without the engine running will result in power drainage
from the battery. Holding the hydraulic switches halfway up
or down also will cause excessive drainage from the bat-
tery.
FIG. 4-3
Clamp In/Out
Clamp Up/Down
Turner
Front Toeboard
Rear Toeboard
Loader
HD0059
